How To Install Rubber Bathroom Flooring

How To Install Rubber Bathroom Flooring

Rubber flooring tiles became a choice of use for homes due to its long-lasting and durable features; it also encompasses absorption of noise in the many functions it has. This is why several homeowners now choose this particular product for their homes. The rubber bathroom flooring is now a trend for bathrooms because this is the way to get non-slip bathroom flooring. Rubber flooring is made from rubbers that have been recycled and processed; this, in turn, makes it a superb choice for your home. The process of installing rubber bathroom flooring is relatively very easy because it requires no extra additives to make it stick. The rubber flooring is easily carved into the shape you want, and sometimes you do not have to cut it.

How To Install Rubber Bathroom Flooring

The process of installation is listed below:

First Step – Get the Floor Cleaned

You are required to get the recipient floor cleaned and free from all sorts of dirt like oil, debris, dust and any other form of particles that might hinder the progress of your installation. This is done to make the recipient surface to readily accommodate the rubber flooring and this process will also ease you off any type of unwarranted stress.

Second Step – Chalk out the guidelines

After the first step, you are to proceed by getting chalk to draw a 2 feet line coming from the wall. Then draw another 2 feet line with the chalk from the adjoining wall. This gives you two lines that have a 90-degree intersection angle. This is needed to print out the laying pattern of flooring.

Third Step – Start Laying Tiles

You are to use the chalk printed grids on the floor to begin the process of laying tiles. You are to interlock the rubber flooring as you install them on the floor. Be aware that the room edges closest to the walls of the room would be attended to lastly. Keep up with the process with practical detailing until you have a fully covered floor leaving the floor perimeters out for a start. This is because the rubber tiles have to be cut into shape to fit into the perimeters of the room.

Fourth Step – Install the Edge Tiles

After getting the room’s floor covered, the carved edge tiles will have to be installed in the room’s perimeters. You are to install the tiles and then cut where necessary to fit perfectly into the space left. You can choose to use a sharp knife or straight edge. It is important that you know that you do not butt the tiles too close to the wall. Most of the manufacturers of rubber flooring advise that you leave a space that is relatively equal to the tile’s thickness. This space is needed to accommodate the expansion of the tiles.

Additional Tips

Make sure you do not install these tiles with adhesives; this is because it will help you to easily remove and replace a worn out tile. If you choose at all cost to have the tiles well stuck to the floor, get a double-sided carpet tape to hold the tiles around the edges of the floor.

 

Leave a Reply